Product ID:RP-1257-3 RESIN
MSDS Date:09/23/1986
FSC:8030
NIIN:00-891-3113
Kit Part:Y
MSDS Number: BFTZQ

CIBA-GEIGY CORPORATION, PLASTICS & ADDITIVES DIV

THREE SKYLINE DRIVE
HAWTHORNE, NY 10532

Emergency Phone: 800 334 9481

Info Phone: 914 347 4700

Preparer: PETER HENIGE

Cage: CIBAG

CIBA-GEIGY CORPORATION, FURANE PRODUCTS

LOS ANGELES, CA 90039 US

Telephone: 818-247-6210

Cage: CIBAG

BENTONITE (AS NUISANCE DUST OR PARTICULATES NOT OTHERWISE

CAS: 1302-78-9

RTECS: CT9450000

Fraction By Weight: Fraction by Wt

OSHA PEL 15 MG/M3 TOTAL DUST

ACGIH TLV: 10 MG/M3 TDUST;8990

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

SILICA, CRYSTALLINE - QUARTZ

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: Fraction by Wt

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293

CALCIUM CARBONATE (MARBLE) (LIMESTONE)

CAS: 1317-65-3

RTECS: EV9580000

Fraction By Weight: Fraction by Wt

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9192

BARIUM SULFATE

CAS: 7727-43-7

RTECS: CR0600000

Fraction By Weight: Fraction by Wt

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

ALUMINUM HYDROXIDE (AS NUISANCE DUST OR PARTICULATES NOT

CAS: 10043-01-3

RTECS: BD0940000

Fraction By Weight: Fraction by Wt

OSHA PEL 15 MG/M3 TOTAL DUST

ACGIH TLV: 10 MG/M3 TDUST;8990

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

DIGLYCIDYL ETHER OF BISPHENOL A (EPOXY RESIN)

CAS: 25068-38-6

RTECS: KC2100000

Fraction By Weight: Fraction by Wt

OSHA PEL N/K

ACGIH TLV: N/K

N-BUTYL GLYCIDYL ETHER (BGE)

CAS: 2426-08-6

RTECS: TX4200000

Fraction By Weight: Fraction by Wt

OSHA PEL 50 PPM

ACGIH TLV: 25 PPM; 9293

LD50 LC50 Mixture:N/K
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN IRRITATION:IRRITANT. EYE
IRRITATION:IRRITANT. SENSITIZATION:POSSIBLE IN SUSCEPTIBLE
INDIVIDUALS.
Explanation of Carcinogenicity:MATERIALS IN PRODUCT ARE NOT CONSIDERED
TO BE CARCINOGENS BY NTP, IARC, OR OSHA (MSHA)
Effects of Overexposure:SKIN & EYE IRRITATION & ALLERGIC SKIN &
RESPIRATORY REACTIONS.
Medical Cond Aggravated by Exposure:SKIN & EYE CONDITIONS.

First Aid:EYES:IMMEDIATELY FLUSH EYES W/H*2O FOR AT LEAST 15 MINUTES.
CALL MD. SKIN:WASH W/SOAP & H*2O. REMOVE CONTAMINATED CLOTHING &
LAUNDER BEFORE RE-USE. INGESTION:IF CONSCIOUS, GIVE LARGE
QUANTITIES OF H*2 O. GET MEDICAL ATTN. INHALATION:REMOVE TO FRESH
AIR.GIVE O*2 &/OR ARTIFICIAL RESPIRATION,IF NEEDED.CALL MD.
OTHER:REFERRAL TO MD IS RECOMMENDED IF THERE IS ANY QUESTION ABOUT
SERIOUSNESS OF ANY INJURY

Flash Point Method:PMCC
Flash Point:170 F (77 C)
Lower Limits:N/E
Upper Limits:N/E
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM, WATER
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT
Unusual Fire/Explosion Hazard:DECOMPOSITION & COMBUSTION PRODUCTS MAY
BE TOXIC

Spill Release Procedures:REMOVE SPILLAGE BY ABSORBING IN ABSORBENT
MATERIAL
Neutralizing Agent:N/K

Handling and Storage Precautions:WARNING COMBUSTIBLE. CAUSES SKIN & EYE
IRRITATION. MAY CAUSE ALLERGIC SKIN & RESPIRATORY REACTION. KEEP
AWAY FROM HEAT & FLAME.
Other Precautions:AVOID CONTACT WITH EYES, SKIN, & CLOTHING. AVOID
BREATHING VAPOR OR MIST. AVOID PROLONGED OR REPEATED CONTACT WITH
SKIN. KEEP CNTNR CLOSED.USE W/ADEQUATE VENT.WASH THOROUGH AFTER
HANDLING.NUISANCE DUS T MAY BE GENER WHEN SAND/SAW CURED MATL.

Respiratory Protection:USE NIOSH/MSHA APPROVED ORGANIC VAPOR CARTRIDGE
RESPIRATOR WHEN VAPOR/MIST EXPOSURE IS LIKELY.
Ventilation:GENERAL MECHANICAL & LOCAL EXHAUST IN ACCORDANCE WITH ACGIH
RECOMMENDATIONS.
Protective Gloves:IMPERMEABLE GLOVES
Eye Protection:CHEMICAL WORKERS GOGGLES
Other Protective Equipment:N/K
Work Hygienic Practices:N/K
Supplemental Safety and Health
N/D:NOT DETERMINED. N/E=NOT ESTABLISHED. VAPOR PRESSURE:AT 77F
(25C).KEY1:N1.

HCC:V4
Boiling Pt:B.P. Text:N/D
Melt/Freeze Pt:M.P/F.P Text:N/K
Decomp Temp:Decomp Text:N/K
Vapor Pres:1.22
Vapor Density:N/D
Spec Gravity:1.4 - 1.6
pH:N/D
Evaporation Rate & Reference:N/D
Solubility in Water:INSOLUBLE
Appearance and Odor:WHITE PASTE, WITH SLIGHT ETHEREAL ODOR
Percent Volatiles by Volume:NEGLIG
Corrosion Rate:

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS, ACIDS & BASES
Stability Condition to Avoid:AVOID EXCESSIVE HEAT FOR LONG PERIODS OF
TIME
Hazardous Decomposition Products:COMBUSTION MAY FORM TOXIC MATERIALS,
SUCH AS CARBON DIOXIDE, CARBON MONOXIDE

Waste Disposal Methods:CONSULT QUALIFIED LOCAL OR CORPORATE PERSONNEL
FOR METHOD THAT WILL COMPLY WITH LOCAL, STATE & FEDERAL HEALTH &
ENVIRONMENTAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.